About Us

ten years of experience ,only for service

Double Sided Flexible Circuits & Circuitries
Double sided flexible circuit board consists of double-sided flexible copper clad material with coverlay opening on one or two sides.  There’re two conductive trace layers (normally copper) with an insulating layer (normally Polyimide) in the middle, and two conductor layers were electronic connected via plated through holes (PTH). Sometimes, there’s no PTH in double layer flexible circuit, as the design purpose of bottom trace is to support rigidness of circuit, or as impedance controlled, or other special purpose.
The coverlay was made of Polyimide and already pre-cut before laminated to copper trace, so that the trace PAD and gold fingers can be accessed from both sides through the coverlay or soldermask opening. Flexible Oil also can be used as coverlay or soldermask to protect traces from oxidation and soldering.
2 Layer flex circuits allow for more complicated circuit designs than a single-sided FPC and a dual access FPC , increase the wiring density per unit area, and further space savings are realized by mounting components on both sides.

All stiffener, adhesive tape, EMI shield material and other material can be placed on anywhere of double layers circuits.  

Double Sided Flexible Circuit Stack Up / Structure
As double sided FPC is the most popular type of flexible circuit, so there’re various combination of different material. There’re five basic layers, from top to bottom (didn’t list the adhesive between):

  1. Coverlay (top)
  2. Copper trace (top)
  3. Polyimide: between two copper trace
  4. Copper trace (bottom)
  5. Coverlay (bottom)

Here is the most popular stack up /layer up of double layer flexible circuits:
 
Adhesiveless laminate also available and in fact, it’s very popular, as engineer want thinner thickness, bigger bend radius, chemical and high temperature, low outgassing, dimensional stability, more flexibility, longer life cycles, and impedance control and so on.
 

Double Sided Flex Printed Circuit Board Samples
Here are pictures of double sided flexible circuit produced by us.
 
Click to see more photos of double sided flexible printed circuit. manufactured by Best Technology in China, to see how it can be used in various application.

Capability of Double Side Flexible Circuit:
Copper thickness: 1/3OZ, 1/2OZ, 1OZ, 2OZ, 3OZ, 4OZ
Polymide thickness (in base material): 1/2mil, 1mil, 2mil, 3mil, 4mil
Board thickness: 0.10mm ~ 0.44mm
Maximum Dimension: 220*1,500mm
Min PTH: 0.10mm
Min LW/LS: 2mil/2mil (0.5OZ)
Impedance control: Most popular values are 50 ohm, 90 ohm, 100 ohm, other values also available

Manufacturing Process of Double Sided Flex Circuit
Here is simple manufacturing process of double sided flex circuits, welcome to visit Best Technology factory in China, to see the real manufacturing process of flex circuit, then you will know better how to make 2 layers flex circuit, to see how Best Technology transfer your circuit board layout into real flex circuit.
 

Please contact Best Technology today for more information or any enquiry for double sided flexible circuit board.

Inquiry


    send-icon Send your message to us Email: fpcsales@bestfpc.com